DIYAPASON-L Digest #758 - Tuesday, February 25, 2003
 
Bushing around combination pistons
  by "James Henry" <jimhen3ry@earthlink.net>
 

(back) Subject: Bushing around combination pistons From: "James Henry" <jimhen3ry@earthlink.net> Date: Mon, 24 Feb 2003 21:59:15 -0800   Any words of wisdom on rebushing the holes on the trim piece that the combination pistons go through? Should the bushing felt be flush with the front of the board or project slightly? Will hot glue set up quickly = enough or should I devise some sort of caul to press the bushing tightly against the wood? Should the strips be cut to length before gluing or after? Thanks, Jim Henry